For some high-rise buildings, elevators must be installed. When construction workers install elevators, we will see outside that the construction team usually installs a construction elevator door at the door of the elevator. In this way, he can effectively isolate some dangers, because there may be some safety hazards during construction. In this way, the safety of workers can be more guaranteed, and the construction can be more standardized. Then, let's introduce the correct use of elevator construction.


1. Carry out safety inspections
When the construction elevator runs for the first time, it must run with no load or full load. The ladder cage should be raised about 1m from the ground to stop, check the sensitivity of the brake, and then continue to rise the floor platform, and check that the construction elevator protective door is normal before it can be put into operation. The load must be evenly distributed when the ladder cage is loaded with people. It is strictly forbidden to operate the button when the passenger elevator runs to the uppermost and lowermost floors. It is strictly forbidden to stop using the stroke limit switch to automatically collide. The construction elevator must be honked before starting. Warning, adequate lighting should be provided for night operations. When a double-cage elevator is under inspection or maintenance, the other one must not run.


2. Safety protection requirements
The facade is made of small-hole expanded metal mesh or barbed wire mesh and steel plate welded, which can effectively prevent the waiting construction workers from extending their handles and causing accidents in the operation of the construction elevator, which is convenient for elevator operators to observe the situation in the building. It also facilitates communication inside and outside the building. A warning slogan and a warning line on the skirting board below are sprayed in the middle of the facade to alert the construction personnel. The door shaft is welded with a 16# round tube, which is easy to install. You only need to weld a 90-degree right-angle round tube on the outer frame pole at the position corresponding to the door shaft, and then hang the protective door to use, and it is easy to remove and remove.





3. Operate strictly in accordance with the requirements
During construction on the site, we must use the protective door of the construction elevator in strict accordance with the requirements of the specification. Do not enter rashly, and do not work carelessly under unknown circumstances. We must know that this is a major event related to the entire family and whether the construction project can be carried out safely and smoothly. . When choosing a protective door for construction elevators, you must choose strictly according to the specific requirements of the construction site. It is good to choose the appropriate one that meets the construction specifications of the site. Every construction worker must take strict precautions and put safety in the first place. The responsibility is greater than the sky.

When we install elevators, it is very necessary to install a construction elevator door at the elevator door, so that not only the construction safety of workers can be guaranteed. It can also effectively isolate safe areas and dangerous areas, so that the general public can be more assured and at ease. For the correct use of elevator doors in construction, the above is all of today's content. More safety issues of passenger elevators are introduced. Please pay attention to our website in detail.