Brief description: Press the call direction button correctly, press "" when going up; press "" when going down. (For the group control call elevator system at the destination floor, please follow the elevator instructions).
Wrong operation: Press the outbound button several times or press the up and down outbound buttons at the same time.
Correct operation: In the waiting hall, when you need to go upstairs to the destination floor, please press the upside call button "", and when you need to go downstairs, please press the outside call button "". The button light is on to indicate that the call has been registered (if the button has been pressed by other passengers, there is no need to press it again), and the car is about to stop at the landing. When the car arrives at the landing, the door will automatically open, and passengers can confirm that the car will go up or down by the direction indicator. If the car runs in the same direction as the calling direction, the light of the outbound button that has been pressed will go out, indicating that the passenger can take the elevator; if the direction is opposite, the outbound button light will not go out and the passengers still need to wait.
2. How to get in and out of the car
Brief description: Go out first, then enter, without stopping at the door of the car.
Correct operation: When the floor and car doors are open, passengers should go out first and then enter. When entering, passengers should stand on the side of the door and let the passengers going out go first. Passengers entering and exiting should not push each other. Pay special attention to the sill gap when entering and exiting.
Example 1: Before entering the car, please make sure that the car door on the elevator floor is fully opened and then see if the car has stopped on the leveling floor, and do not rush forward.
Example 2: Before entering the car, you should wait for the car door on the elevator floor to be fully opened and then see that the car floor and the floor of this floor are on the same plane. Don't move in a hurry (a faulty elevator will level the floor incorrectly) to avoid tripping. Do not hold the door panel with your hands, and it is forbidden to reach into the gap between the car door and the hoistway.
Example 3: When entering the car, you should pay attention to crutches, high heels, umbrellas and other sharp protrusions not to get stuck in the floor car door sill groove or between the gap between the two to avoid danger.
Example 4: It is forbidden to hold hands or lean against the safety touch panel (or light curtain), so as not to affect other people's riding or the closing of the floor or car door, or even personal injury may occur when the door is opened.
3. How to open and close the elevator door
Brief description: Press the hall call button or the car door open button to open the door again. Press the door close button in the car to close it.
Correct operation: The floor and car doors will automatically close after a few seconds after opening. If you need to delay closing the car door, press and hold the door open button "" on the control panel in the car; or press the outbound button in the same direction outside the hall door. If you need to close the car door immediately, press the door close button "
Wrong operation: When the elevator floor and car door are about to be closed, use your body, hands, feet, etc. to directly prevent the door from closing.
For example: When the elevator floor and car door are closing, in order to catch the elevator or worry about delaying to get out of the car, use hands, feet, body or sticks, trolleys, etc. to directly prevent the door from closing, although the floor and car doors are under normal circumstances with safety protection It will automatically re-open under the action of, but if it is in the safety blind zone or the door system fails, it will cause serious consequences.